Touch Sensor for LED Screens: Turn a COB Video Wall into a Giant Whiteboard
- kashiwagi4
- 1 日前
- 読了時間: 3分
Want to write directly on the big screen in your meeting room? You can — by adding a touch sensor frame to a standard LED video wall. XIV visited a partner’s site to try a working unit hands-on. The key finding: the sensor itself is not an expensive part, so once the LED screen is specified, adding large-format touch is a small step. This article covers how it works, the higher-grade model, mounting options and power draw, together with the hands-on video.
Conclusion: touch capability is just a sensor frame added to a COB LED monitor
A touch-enabled LED screen is simply a standard COB (Chip on Board) LED monitor with an infrared touch sensor frame fitted along the bottom edge. The panel itself stays standard, so the extra cost is only the sensor frame.
Base unit is an ordinary COB LED monitor — no special panel required
The sensor frame sits along the bottom edge, protruding slightly from the LED surface
Touch response is accurate; handwriting on screen works smoothly
In meetings, you can annotate directly over a mirrored PC screen
How it works: COB monitor + touch sensor frame
COB construction mounts LED chips directly on the board and seals them in resin, giving a flat, durable surface — a good match for a display that people touch every day. The risk of individual LEDs being knocked off is far lower than with SMD panels.
Standard vs. higher-grade model
Feature | Standard | Higher-grade |
Touch operation | Yes | Yes |
External input | Cable (depends on config) | HDMI input |
Volume control | No | Built in |
Frame | Standard | Premium finish |
Typical use | Meeting rooms, signage | Meetings, presentations, education |
Cost: the sensor is the cheap part
The takeaway from the visit: the touch sensor itself is inexpensive. Most of the budget is determined by the LED screen — size and pixel pitch. See our pricing page for indoor LED display pricing, then add the touch frame as a small increment.
Mounting: stand or wall
Method | Notes |
Floor stand | Movable between rooms; needs floor space |
Wall mount | Screws into holes on the rear; note the extra depth added by the sensor frame |
Large models | Mounted together with the frame; check wall strength |
Power consumption: roughly 370–400 W per m² (COB)
One power cable is all it takes. COB draws less power than SMD; plan on roughly 370–400 W per square metre. A meeting-room-size screen runs comfortably on ordinary office power.
Where it fits
Meeting rooms — replace the whiteboard with one large touch display
Presentations — annotate over slides in real time
Education — a bright, large-format electronic blackboard
FAQ
Can a touch sensor be added to an existing LED display?
In many cases yes, since the sensor mounts as a frame along the bottom edge. Send us the panel type, size and installation photos and we will confirm.
How accurate is the touch response?
On the demo unit, touches registered exactly where pressed and on-screen handwriting was smooth — fully usable for meeting annotation.
How much does touch add to the cost?
The sensor is a minor line item. The overall budget is driven by the LED screen itself (size and pixel pitch); the touch frame is quoted as a small addition.
Is wall mounting possible?
Yes. The rear has screw holes for fixing, and large models mount together with the frame. Allow for the extra depth created by the sensor frame.
コメント